Skip to content

Guide section / Servicing and Cleaning

What a Normal Aircon Service Visit Should Cover

What a normal service visit covers, how long it takes and what the technician should check.

4 min read Last updated
Technician on a step ladder servicing a wall-mounted aircon in an HDB bedroom, filters laid on a towel

What general servicing is for

Wondering what aircon servicing includes, and whether you’re paying for the right thing? We get that question a lot from HDB owners, condo owners and landlords.

General servicing is the routine cleaning visit for a wall-mounted split aircon. It keeps air moving, keeps the drain clear and catches small problems early. It isn’t a repair, and it isn’t a deep clean. A chemical wash or overhaul is a different, longer job.

Most homes in Singapore run aircon for long hours, often every night. Warm, humid air carries dust and moisture into the unit, and relative humidity here often sits above 80 per cent. The coil stays wet while the unit runs, which suits mould. The drain line collects slime too.

That’s why servicing matters more here than in cooler, drier places. We’ll walk you through what a good visit looks like, so you know what you’re paying for.

What a normal visit should cover

For each indoor unit, a general service should include:

  1. Air filters. Removed, washed and dried or wiped before refitting.
  2. Evaporator coil. The front face cleaned of dust so air can pass through.
  3. Blower wheel. Cleaned where it can be reached without dismantling.
  4. Drain pan and condensate drain pipe. Slime cleared and the line flushed so water flows out freely.
  5. Outdoor unit check. The condenser looked over for blockage, and the brackets and aircon ledge checked. BCA advises owners to have brackets checked during servicing.
  6. Test run. The unit runs at the end so you can feel cold air and see no drips.

Some providers also add a gas pressure check to their general service. Ask whether yours does, and whether it costs extra.

Wall-mounted aircon with the front cover lifted, showing the coil and blower wheel during a service

What you should see before the technician leaves

You don’t need to watch every step, but someone should be home to give access and check the result. This matters even more if you’re a landlord. A tenant who finds a dripping unit a week later will call you, not the technician.

Before the technician leaves, look for these:

  • Filters back in place and clean.
  • The drain tested. Ask to see water flowing from the outlet.
  • No water sitting in the drain tray.
  • Covers fitted properly, with no rattles when the unit runs.
  • The area under the unit wiped down.
  • A receipt listing the units serviced, the date and the warranty terms.

A visit that takes about ten minutes per unit is a warning sign. Many Singapore providers quote around 30 to 45 minutes for a single unit, though the time varies with the model and its condition. If you have a multi-split system, expect the visit to stretch with each indoor unit. Our guide on how long servicing takes explains what drives the time and the signs of a rushed job.

Filters and drains between visits

You can stretch the gap between services by cleaning the filters yourself. Switch off, slide them out, rinse them, let them dry fully and refit. The filter cleaning guide shows the steps.

Drain lines are different. You can watch the outlet, but flushing the line is technician work.

PartSafe for you to doLeave to the technician
Air filtersSwitch off, slide out, rinse, dry fully and refitWashed and refitted at each service
Coil and blower wheelLook with a torch only, unit offCleaned where they can be reached
Drain pan and pipeWatch the outlet for water flowSlime cleared and the line flushed
Outdoor unit and bracketLook from inside only; never climb outCondenser and brackets checked

Our DIY cleaning vs professional servicing guide sets out where the safe limit is. It also explains why spraying cleaners into the unit causes more problems than it solves.

Outdoor units and brackets

The outdoor unit, or condenser, sits on an aircon ledge or bracket outside the home. Brackets rust in Singapore’s rain and humidity. BCA advises having them checked during servicing, and its guidance suggests inspecting supports for corrosion or damage at least every six months. Badly corroded brackets should be replaced with stainless steel ones.

Never climb out to inspect a bracket yourself. Leave it to a trained installer. The outdoor unit bracket guide explains what to ask for.

Still weak after a service?

If cooling or airflow is still weak after a service, the cause may be build-up a general service can’t reach, a fan motor fault, or a gas leak. Aircon still weak after servicing covers what may have been missed and when to use the warranty.

Now you know what aircon servicing includes, and what a fair visit looks like. Next, check the numbers. For prices, see the Aircon Servicing Cost section. For how often to book, see Servicing Frequency.

General service scope checklist

Air filters
Removed, washed, dried
Evaporator coil
Cleaned at the front
Blower wheel
Cleaned where reachable
Drain pan
Cleared of slime
Condensate drain pipe
Flushed and flow tested
Outdoor unit
Checked, incl. brackets
Test run
Cold air, no drips

What a normal visit should cover for each wall-mounted unit.

Outdoor unit cleaning may be charged separately. Ask before the visit.

What to Look For: Signs and Parts in Photos

Illustrative photos of the parts and signs this section talks about. They are not job records.

Two clean aircon filters drying on a rack by a window
Air filters are the first thing a service cleans, and the one part you can clean yourself.
Aircon drain hose outlet dripping over a floor trap on a service yard
The drain pan and condensate pipe should be cleared and tested at every service.
Rust-streaked bracket under an outdoor aircon unit on an HDB facade
BCA advises having outdoor unit brackets checked during servicing.
Murky water left in an aircon drain tray after a quick visit
Standing water in the tray after a visit suggests the drain was not cleared.

Safe Checks to Do Before You Book Anyone

Switch the unit off before touching anything. Never open electrical parts or handle refrigerant.

  1. 01 Switch the unit off at the remote and the isolator before touching the filters.
  2. 02 Lift the front cover and slide the filters out. If they are grey and matted, cleaning them may restore airflow.
  3. 03 Look at the drain outlet outside or on the service yard while the unit runs. A steady drip is normal; nothing at all can mean a blockage.
  4. 04 From inside the home only, look at the outdoor unit. Note rust on the bracket or leaves on the grille. Never climb out to check.
  5. 05 Write down when the unit was last serviced and any symptoms, so the technician starts with facts.

When a Service Is Not Enough: Call a Technician

Filter cleaning is the only internal job most owners should do. Book a service for the rest.

  • The unit has not been serviced for a long time, or you cannot remember the last visit.
  • Airflow or cooling is weak even with clean filters.
  • Water drips from the indoor unit or stains the wall below it.
  • There is a musty smell at switch-on that does not fade.
  • The outdoor unit bracket looks rusty or loose.

General Servicing: questions readers ask

What is included in general aircon servicing?

Cleaning the air filters, the evaporator coil and the blower wheel where they can be reached, clearing and flushing the drain pan and drain pipe, a check of the outdoor unit and its brackets, and a test run at the end.

Can I clean my aircon myself instead?

You can safely clean the air filters and wipe the cover after switching the unit off. Coil, blower, drain and electrical work need a technician. Do not open electrical parts or spray chemicals inside the unit.

Does general servicing include a gas top up?

No. Refrigerant sits in a sealed system and is not a routine item. A top up is a separate job and should follow a confirmed cause, usually a leak.

Is outdoor unit cleaning part of a general service?

A check of the outdoor unit should be. Cleaning it may be charged separately, so ask before the visit.

Is ten minutes per unit enough?

Usually not. A full general service includes several steps per unit, and ten minutes is a common red flag for a rushed job.

All Guides in This Section

Each guide covers one problem or one decision.