Skip to content

General Servicing

Aircon Still Weak After Servicing?

Why cooling or airflow can stay weak after a service: build-up a service cannot reach, gas or electrical faults, and warranty next steps.

4 min read Last updated
Person holding a hand up to an aircon vent in a warm bedroom, frowning slightly

First, rule out the simple things

An aircon that is weak after servicing is often a settings or refitting slip, and you can check four things in two minutes before you call. On a multi-split system, test each indoor unit on its own, because one can be fine while another is not.

  • The remote. Cool mode, a sensible temperature and the fan not set to the lowest speed.
  • The filters. Were they refitted properly? Is one missing or sitting crooked?
  • The louvres. Are they open and moving?
  • The outdoor unit. Seen from inside, is its fan turning when the unit runs?

If all of that looks fine, the cause is likely one of three things below. The General Servicing section explains what a normal visit should cover, which helps you judge what may have been missed.

1. Build-up a general service cannot reach

Yes, a unit can still be weak after cleaning, because a general service only cleans the front of the coil and the reachable parts of the blower. If mould and dust sit deep in the coil or across the back of the blower wheel, airflow and cooling stay weak. Units that went a long time between services, or that run every night, are the usual suspects.

Most Singapore technicians suggest a general service every three to four months for typical home use, with a chemical wash once or twice a year. If yours has gone longer than that, deep build-up is a fair first guess.

The fix is usually a chemical wash, or an overhaul for very heavy build-up. See general servicing vs chemical wash.

Fresh aircon service receipt pinned under a fridge magnet in an HDB kitchen

2. A fault that servicing does not fix

If the unit is not cold after servicing, a fault is the next thing to rule out, because servicing cleans but does not repair. Any of these will survive a service visit:

FaultTypical sign
Refrigerant leakAir moves but is not cold; ice may form on pipes
Fan motor failingBlower spins slowly or stops, weak airflow
Outdoor unit faultOutdoor fan not turning, warm air indoors
Electrical or control faultUnit stops, restarts, or shows error lights

Ice on the pipes is worth a closer look. HVAC references list two common causes, weak airflow across the coil or low refrigerant, so a heavily dirty coil and a leak can look alike from the outside. Switch the unit to fan mode so the ice melts, then book a diagnosis.

These faults need diagnosis. A technician usually charges a troubleshooting fee to find the cause and quotes the repair separately. See the troubleshooting fee guide.

Outdoor aircon unit on an HDB ledge with the fan not spinning

3. Something was missed

Sometimes a step was skipped or done poorly, and you can usually spot it with a quick look. Check for these signs:

  • Water left in the drain tray.
  • A coil that is still visibly dusty.
  • Filters refitted while still wet.
  • A visit that felt far shorter than the job you paid for.

The how long servicing takes guide lists the signs of a rushed visit. Take photos of anything you find before you call, since they make the conversation much quicker.

Use the warranty

If your problem started right after the visit, contact the servicing company within the warranty period. Most companies give a workmanship warranty on servicing. As a dated example, the partner whose prices we cite states 90 days.

When you get in touch:

  • Describe the symptom and when it started.
  • Send the receipt and the date of the service.
  • Ask them to return and check the unit.

The warranty claim guide explains what a workmanship warranty usually covers and what it does not, such as faults unrelated to the work.

Be careful with quick fixes

Do not agree to a gas top up until you know how low refrigerant was confirmed. A unit that was cooling fine before servicing does not usually lose gas because of servicing. Topping up without finding the leak also only buys time, since the gas will escape again.

Before you approve the work, ask three things:

  • How was low refrigerant confirmed?
  • Where is the leak, and will it be found and fixed?
  • What does the quote include, and is it in writing?

See does my aircon really need a gas top up?

When to call a technician

Call the company that serviced the unit first if your aircon is weak after servicing and the problem appeared right after the visit, as long as you are within the warranty. Call for a diagnosis if the unit was already weak before the service, or if you see ice on pipes, hear buzzing, or the outdoor fan does not turn.

Not sure which applies? Run the two-minute checks at the top, note the symptoms and the service date, then contact the company with those details in hand. We find that a clear description gets you a faster, fairer answer.

Questions readers ask

Why is my aircon still not cold after servicing?

Deep build-up the service could not reach, low refrigerant from a leak, an outdoor unit problem or an electrical fault may remain. Servicing cleans; it does not repair.

Should the company come back for free?

Check the workmanship warranty on your receipt. If the problem relates to the work done and you are within the period, contact the company and ask them to return.

Do I need a chemical wash next?

Possibly, if build-up is the cause. If the technician finds a leak or a failing part, a repair is needed instead.

Back to the section

What a normal service visit covers, how long it takes and what the technician should check.

Learn more about General Servicing