Skip to content

Common Faults

Safe Checks Before Calling an Aircon Technician

A short safe checklist before calling an aircon technician: remote and mode, breaker status, filter, outdoor unit obstruction and notes.

3 min read Last updated
Hand checking an aircon remote's mode setting in a bedroom, unit on the wall behind

Why check first

Most no-cooling call-outs we see end with a simple cause. A remote in the wrong mode, a tripped breaker or a clogged filter will do it.

A technician visit usually comes with a troubleshooting fee for diagnosis. Singapore providers commonly quote around $40 to $60 for it, so ten minutes of aircon checks before calling a technician can save you money and a wasted trip. The Common Aircon Faults section explains what each symptom usually means.

These checks are safe because they need no tools and no opening of electrical parts.

Below, we’ll walk through five quick checks, what to note down, and which signs mean you should stop and call.

The checklist

Work through these five checks in order. Each takes about a minute, and you can do them from the floor.

1. Remote and settings

Start with the remote, because it causes more false alarms than any faulty part. If you have a multi-split system, test each room’s remote separately. One room failing while the others cool usually points to that indoor unit or its remote, not the shared outdoor unit.

  • Is it in cool mode? Fan and dry modes do not cool much.
  • Is the temperature a few degrees below the room? NEA suggests 25°C, and that is usually enough in a Singapore home.
  • Is the fan speed reasonable, not on the lowest setting?
  • Are the batteries fresh? A weak remote can fail to send changes.
  • Has a timer or sleep setting switched the unit off?

2. Power and breaker

Check whether the unit shows any sign of life, then look at your distribution board. A breaker in the off position is the most common reason a unit stays dead.

  • Does the unit’s display or indicator light come on?
  • Look at your distribution board. Is the aircon breaker in the off position?

Home distribution board with breakers in an HDB flat corridor

Note what you see. Do not open the board or any cover. If a breaker has tripped and trips again after being switched back on, leave it off and tell the technician. A tripping breaker can point to an electrical fault.

3. Air filters

Switch off, lift the front cover and look at the filters. If they are grey and matted, clean them. A common rule of thumb is every two weeks if you run the unit daily, since Singapore’s dust and humidity clog filters quickly. See how to clean aircon filters.

4. Outdoor unit

From inside the home, look at the outdoor unit while the indoor unit runs. Is its fan turning? Are leaves, cloth or objects blocking it? Never lean out or climb onto a ledge. If you can’t see it safely, skip this check and tell the technician.

5. Water and smells

Look and sniff. A burning smell means switch off now and call.

  • Is water dripping from the indoor unit itself?
  • Is the drain outlet dripping as usual?
  • Is there a musty or sour smell? See why an aircon smells musty.

Make notes for the technician

Good notes shorten the diagnosis. Jot these down before you call, and take a photo of the unit label.

Notepad with aircon symptom notes and a phone showing a photo of the unit label

NoteWhy it helps
The symptom, in your wordsStarts the diagnosis
When it started, sudden or gradualSeparates faults from build-up
Which units are affectedPoints to indoor or outdoor causes
What you checkedSaves repeat checks
Unit age and refrigerant typeGuides parts and gas questions
Last service dateShows if build-up or warranty applies

If you rent out your unit, ask your tenant to send the label photo and a short video of the problem. That lets the technician arrive with the right questions answered.

Stop and call straight away if

Switch the unit off, leave it off and call if you notice any of these signs.

  • You smell burning or see sparks.
  • You hear buzzing, grinding or loud clicking.
  • A breaker keeps tripping.
  • Ice forms on the copper pipes. Leave it to thaw and don’t chip it off.
  • Water is reaching sockets or another home.

When to call a technician

Call when a problem remains after the checks above, or straight away for any of the stop signs. Expect a troubleshooting fee for diagnosis and a separate quote for any repair. The troubleshooting fee guide explains how that works.

Keep your notes and unit label photo handy when you phone. After these aircon basic checks, you’ll give the technician a clear starting point.

Questions readers ask

What should I check before calling?

The remote mode and temperature, the breaker status, the air filters and the outdoor unit. Then note the symptoms.

Can I reset the breaker?

Look at the board to see whether a breaker has tripped and note it. Do not open the board or any electrical part. If a breaker trips again, leave it off and tell the technician.

What should I tell the technician?

The symptoms, when they started, which units are affected, what you checked, the unit's age and refrigerant type if you can see the label safely, and the last service date.

Back to the section

Weak cooling, water leaks, smells, weak airflow and noise, and which of them a service fixes.

Learn more about Common Aircon Faults